If you want to hear iron why would you not run it to 3 or more? lower number less you hear or higher the number the more..? +Quote
CDDZ
Squirrel,
The flasing I get is when I swing the coil over the ground surface. The falsing sounds like a whisper deep target. I swing the coil at a smooth and normal speed. I can tolerate it being choppy from running hot(used to own a T2). There are times that I chase a disappearing target that will repeat both directions( I believe this is due to a GB issue). If I happen to bump it against a mole hill( lot of those little suckers around here), I will get a loud false. I also notice a whine when I am planting my digging tool into the ground or walking.(in cadence with my step or thrust).
These are the settings I am using when this "whisper false" is happening.
Notch 00-00
Disc 0
Tones Full
Sens 90 (turn it up or down depending on chatter)
TX 2
8 kHz
Iron volume 00
React 01
Silencer -1
Audio Re 4
Manual GB
Ground Notch 00
Quote
squirrel1
Please describe again what you are doing.
Meaning are you bumping the coil--- for the false
In full tones when you get a supposed false signal-- does it repeat with sweeps???
I believe it or not have never used ground notch, and really have never experienced in falsing.
But I don't swing my detector like I'm chopping wood either.
The Deus is sorta chatty-- but this is not to be confused with falsing
And the chained really doesn't seem to prevent a person from detecting good targets.
You may be expecting the Deusmto sound more like a CTX, I don't know.
Do you have a video camera to video and posts here???
I want to help, but am limited based on info.
If I had to place a bet--- your Gb is too negative--- or machine is tracking too negative---- this happens in sites especially loaded with iron etc.
↧
Re: So much Falsing
↧