Quote
squirrel1
Thanks for posting that I wondered why I kept getting so much ground noise when I switched from trash program to deep program basically the same program except for the reactivity being changed from 3 to 1 and the noise starts. Does this happen if you switch from full tones to say 5 tones? Or is it in full tones only or does it do it when you drop reactivity in any tones?Ive used full tones since ever since I got my deus so no expereince with the others.Quote
Gary-B
*Discrimination notes : Disc 0 will accept all the ground noise as a baseline, this is good if you want to hear ground changes. Disc 1 will eliminate ground noise and only accept Iron as a baseline.
Here is what I notice,,,when running full tones,,0 disc,,reactivity 3 and 4 are very quiet when there are no targets,,ferrous and nonferrous
Now drop to reactivity 2, or 1 , or 0 --- I get ground noise with full tones. 0 disc,,and I also get it with level 1 disc,,and level 2 disc--- disc level 3 seems to run quiet ground noise wise.
Btw running a dead on o slightly positive GB-- running both ways ground balance wise,, acts like I stated above.
I am not complaining,,or even asking a question-- just sharing my experiences.
↧
Re: 13" coil info
↧